Ives 7259 Bedienungsanleitung PDF herunterladen

7259

Bottom Center Pivot

Improper pivot set installation can lead to personal injury or property damage. Follow

all instructions carefully. For questions contact Technical Support at 1-888-371-7331.

CAUTION

1. Prepare and mortise bottom of door and floor to receive pivot set. Determine pivot location using

dimensions on reverse side. Be sure to properly locate base plate. The finish plate of pivot base

assembly should be removed until installation is complete.

2. Prepare bottom of door. If bottom of door has not been prepared prior to pivot installation, mortise per

dimensions on reverse side. The bottom of the door must have a removable heel section (Figure 1).

3. Remove pivot clamp from door pivot leaf with 5/16” Allen wrench. Locate, drill, and tap mounting holes

for door leaf. Mount door leaf in bottom of door with screws provided.

4. Locate and prepare cutout in floor for pivot base. The pivot base assembly must be located so that the

center line of top pivot point is plumb with center line of base pivot point. Secure pivot base:

A. Prepare compound that will be used to fill around pivot base (concrete, cement, grout, etc.).

B. Fill cutout with compound, leaving room for concrete channel base to fit flush with floor.

C. Set pivot base into cutout. Align base assembly so pivot point is in proper position.

D. Use a level to be sure pivot base assembly is level on all sides.

E. Secure in proper position until compound sets up completely. Once compound has set up, mounting

screws can be removed, allowing removal or replacement of pivot base assembly.

F. Re-attach finish plate.

5. Maneuver door into position, about 90° to frame. Position door so door pivot leaf mates with pivot pin

as shown in Figure 2. Re-attach pivot clamp as shown in Figure 3. Do not tighten clamp screws

completely. Engage pivot leafs at top of door. Now tighten clamp screws securely.

6. If height adjustment is necessary for proper clearance, use shims between door bottom and pivot

leaf to increase clearance. To decrease clearance, mortise in door must be made deeper.

Clamp

screws

Pivot clamp

Finish

screws

Finish plate

Mounting

screws

Concrete

anchor pins

2” minimum door thickness.

NOTE

Figure 1 Figure 2 Figure 3

Door

leaf

Base

plate

Pivot

Concrete

channel base

Installation Instructions

1 2

Installation Instructions 1
26633-00 2

Inhaltsverzeichnis

Seite 1 - Installation Instructions

7259 Bottom Center PivotImproper pivot set installation can lead to personal injury or property damage. Followall instructions carefully. For question

Seite 2 - 26633-00

26633 Rev. 4It is very important for installer to verify that center line of top pivot point lines upwith center line of bottom pivot point before fin

Kommentare zu diesen Handbüchern

Keine Kommentare

Ives 7259 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Nein Ives 7259 herunter. Ives 7259 User's Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein Ives 7259