Ives Offset Top Pivot 7222 Bedienungsanleitung PDF herunterladen

7222

3/4” Offset Bottom Pivot

Improper pivot set installation can lead to personal injury or property damage. Follow

all instructions carefully. For questions contact Technical Support at 1-888-371-7331.

CAUTION

1. Prepare and mortise bottom of door and floor to receive pivot set. Determine pivot location

using dimensions on reverse side. Be sure to properly locate and mark pivot center

point of the base plate. The bottom pivot set is handed. Hand of pivot set must match hand

of door. To determine hand of door, see diagrams above.

2. Locate, drill, and tap 1/4-20 mounting holes for metal door. Locate and drill pilot holes for #14 wood

screws for wood door. Mount door leaf in bottom of door with 1/4-20 x 3/4” FHMS or #14 FHWS screws.

3. Drill 3/4” dia. x 1-3/4” deep hole in floor on center of pivot point for base plate mounting.

Insert anchor pin and expand with tool. Insert base plate screw provided. Grout anchor pin

in place. After grout has set, remove base plate screw.

4. Place base plate over anchor pin. The notch in base plate is to clear corner of frame. Fasten

to floor with base plate screw. Tighten securely.

5. Thread bearing spindle all the way into base plate, then back out one full turn. Use Allen wrench

to tighten set screw securely, locking bearing spindle in place. If threshold is used, install now.

6. Install top pivot set and hang door. Refer to top pivot set instructions. If height adjustment is

required for proper door clearance, adjust bottom pivot as follows:

A. Loosen set screw using 3/32” Allen wrench provided (see diagram above).

B. Use 5/8” Allen wrench to adjust pivot shaft height as needed. Range is plus 1/4”, minus 1/16”.

C. Tighten set screw firmly.

Right hand

installation

Left hand

installation

Right hand

installation shown;

left hand opposite

Base plate screw

Base plate

Anchor pin

3/32” set

screw

3/32” Allen

wrench

Door leaf

Bearing spindle

Installation Instructions

1 2

Installation Instructions 1
16001-00 2

Inhaltsverzeichnis

Seite 1 - Installation Instructions

7222 3/4” Offset Bottom PivotImproper pivot set installation can lead to personal injury or property damage. Followall instructions carefully. For que

Seite 2 - 16001-00

Pivot BaseDoor Leaf9/16”14 mm1-1/8”29 mm16001 Rev. 4Depth of mortise will varydepending upon installationand/or threshold height.*3/8”10 mm*15/16”24 m

Kommentare zu diesen Handbüchern

Keine Kommentare

Ives Offset Top Pivot 7222 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Möbel Ives Offset Top Pivot 7222 herunter. Ives Offset Top Pivot 7222 User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Möbel Ives Offset Top Pivot 7222