Ives Offset Top Pivot 7245F Bedienungsanleitung PDF herunterladen

7245F

1-1/2” Offset Bottom Pivot

Improper pivot set installation can lead to personal injury or property damage. Follow

all instructions carefully. For questions contact Technical Support at 1-888-371-7331.

CAUTION

1. Prepare and mortise bottom of door and floor to receive pivot set. Determine pivot location using dimensions

on reverse side. Be sure to properly locate base plate. The finish plate of pivot base assembly should be

removed until installation is complete. Bottom pivot set is non-handed. The pivot shaft will thread into either

side of door leaf. To determine hand of door, see diagrams above.

2. Prepare bottom of door: Locate, drill, and tap 1/4-20 mounting holes for metal door. Locate and drill pilot

holes for #14 wood screws for wood door. Mount door leaf in bottom of door with 1/4-20 x 3/4” FHMS or

#14 FHWS screws provided.

3. Locate and prepare floor cutout for pivot base. The pivot base assembly must be located so that the

center line of top pivot point is plumb with center line of base pivot point. Secure pivot base:

A. Prepare compound that will be used to fill around pivot base (concrete, cement, grout, etc.).

B. Fill cutout with compound, leaving room for concrete channel base to fit flush with floor.

C. Set pivot base into cutout. Align base assembly so pivot point is in proper position.

D. Use a level to be sure pivot base assembly is level on all sides.

E. Secure in proper position until compound sets up completely. Once compound has set up, the

mounting screws can be removed, allowing removal or replacement of pivot base assembly.

4. Re-attach finish plate, then hang door.

5. If height adjustment is necessary for proper clearance, adjust bottom pivot as follows:

A. Loosen set screw using 3/32” Allen wrench provided (see diagram above).

B. Use 5/16” Allen wrench to adjust pivot shaft height as needed (Figure 1).

C. Tighten set screw firmly.

6. Fasten pivot cap as shown. Secure with cap screw.

Figure 1

Right hand

installation

Left hand

installation

Door leaf

Concrete

channel base

Base plate

Pivot shaft

Pivot cap

3/32” set

screw

Pivot cap screw

Finish plate

Concrete

anchor pin

Mounting

screws

Finish

screws

Installation Instructions

1 2

Installation Instructions 1
26363-00 2

Inhaltsverzeichnis

Seite 1 - Installation Instructions

7245F 1-1/2” Offset Bottom PivotImproper pivot set installation can lead to personal injury or property damage. Followall instructions carefully. For

Seite 2 - 26363-00

26363 Rev. 3It is very important for installer to verify that center line of top pivot point lines upwith center line of bottom pivot point before fin

Kommentare zu diesen Handbüchern

Keine Kommentare

Ives Offset Top Pivot 7245F Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Möbel Ives Offset Top Pivot 7245F herunter. Ives Offset Top Pivot 7245F User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Möbel Ives Offset Top Pivot 7245F